Foam injection, hydrostatic pressure relief, anchoring, reinforcement, and cap replacement for Cape Coral & Lee County seawalls. We diagnose the real cause, then fix it — the first time.
Every "repair" is really a fix for one specific part of this system. Hover a component to see where it sits — and which service on this page fixes it.
The finished top edge of the wall. Cracks, spalling, or exposed rebar here signal deterioration below the surface.
A horizontal beam behind the wall that spreads tieback load evenly across the face instead of a few weak points.
Rods connecting the wall to an inland anchor, holding it against the pressure of the water and soil behind it.
The buried anchor point — concrete deadman or helical screw anchor — that the tieback system pulls against.
Expanding polyurethane foam fills voids and compacts loose soil behind the wall, stopping ongoing soil loss.
Lets trapped water drain out while keeping soil in — relieving the hydrostatic pressure that cracks walls.
No single-method contractors here. We match the fix to what your wall is actually doing.
Water-activated foam expands to fill voids and compact loose soil behind your wall — no excavation, no torn-up yard.
Vents and filters let trapped water drain safely out, so pressure never builds to a cracking point again.
New or replacement anchoring systems, including low-excavation helical anchors for tight waterfront lots.
Matched tieback pairs and waler reinforcement to spread load evenly and stop uneven wall movement.
Single, continuous reinforced wall sections engineered for your site's specific loads and soil conditions.
Cracked, spalled, or failing caps removed and replaced — restoring both structure and appearance.
Catching these early is almost always cheaper — and simpler — than catching them late.
A visible lean that wasn't there last season, especially near corners.
Cracks or spalling in the cap, or exposed rebar.
Soft spots or sinking soil in the yard near the wall.
Daylight or gaps visible under the cap.
Water seeping through the wall face where it shouldn't.
Clogged or missing weep holes with no visible drainage.
We identify what's actually failing — soil, pressure, anchoring, or structure.
You get a plan matched to the cause, not a one-size-fits-all quote.
Foam injection, anchoring, or reinforcement installed with minimal disruption.
Vents and filters restored so water has a safe way out.
We confirm the fix held, patch up, and leave the site clean.
Led by a master marine contractor, not a subcontracted crew learning on your project.
We're not a "foam-only" or "anchor-only" shop — we apply whatever method your wall actually needs.
Full licensing and insurance, based right here in Lee County, Florida.
Foam and helical anchor methods mean less excavation, less mess, faster turnaround.
Tell us what you're seeing and we'll tell you exactly what's happening — and how to fix it.
In most early-to-moderate cases, yes — foam injection and anchoring repairs cost a fraction of full replacement because they address the soil and pressure causing the damage instead of tearing out and rebuilding the wall. Severely deteriorated or collapsed walls may still need replacement, which we'll tell you plainly during inspection.
Most foam injection and pressure-relief jobs are completed in a single day. Anchoring, reinforcement, or cap replacement projects vary by scope — we'll give you a specific timeline after inspection.
It depends on the scope of work. We handle the permitting conversation as part of the process so you're not left figuring it out on your own.
That's exactly what the inspection is for. We look at soil condition, drainage, anchoring, and the wall face itself, then recommend the method engineered for what we find — not a default service.
Fill this out and it'll open your email app with the details ready to send straight to us.